Finnleo Himalaya 9.0 kW (240V 1PH) Sauna Heater

Finnleo Himalaya 9.0 kW (240V, 1PH) Electric Sauna Heater

The Finnleo Himalaya 9.0 kW is a floor-standing, rock-tower electric sauna heater engineered for larger home and light-commercial saunas. As the higher-output member of Finnleo's best-selling Himalaya family, the 9.0 kW model surrounds its heating elements on every side with a tall column of stone, holding roughly 210 lb of sauna rocks in direct contact with the heat. The result is deep, radiant warmth and an abundant, soft löyly (steam) that fills larger sauna rooms evenly from floor to ceiling.

Built by Sauna360 in Cokato, Minnesota, the Himalaya 9.0 kW is sized for sauna rooms of 310 to 500 cubic feet, making it the right choice for family-size cabins, gyms, spas, and larger custom-built saunas where the 7.0 kW model would fall short. Every unit ships with standard BioWater Technique (BWT) integral water tank technology, letting bathers dial in a softer, more humid steam without sacrificing the dry-heat feel of a traditional Finnish sauna.

Key Features

• Floor-standing rock-tower design with 210 lb rock capacity for maximum heat retention and even heat distribution
• Standard BioWater Technique (BWT) integral water tank for adjustable, continuous soft-boil humidity during the sauna session
• Fragrance diffuser slot built into the BWT tank for optional aromatherapy oils, kept separate from the water reservoir
• Sized for sauna rooms from 310 to 500 cubic feet
• 9.0 kW output on 240V single-phase power (37.5 amps)
• Compact footprint: approximately 13" W x 15" D x 40" H, allowing corner, mid-wall, or through-the-bench installation
• Requires the SaunaLogic2 (SL2) control and matching contactor box for operation
• Built-in high-limit safety control with manual reset button that automatically shuts off the heater if room temperature reaches an abnormal level
• Vulcanite sauna rocks included with every heater
• Heater-only or complete package options available

SaunaLogic2 (SL2) Control Compatibility

The Himalaya 9.0 kW is designed exclusively around Finnleo's SaunaLogic2 control system, available with or without Wi-Fi/Bluetooth connectivity. The SL2 control lets bathers set:

• Sauna temperature from 119°F to 194°F (typical bathing range 150°F–165°F)
• Session duration from 0 to 60 minutes
• A pre-set delayed start of up to 24 hours
• Optional RGBW lighting sequences (White, Red, Green, Blue, Yellow, Aqua, Purple, or rotating colors) at 25%, 50%, 75%, or 100% brightness, supporting a lighting package of 3 to 8 fixtures
• Optional Bluetooth audio operation, when the Bluetooth package is purchased with the system

All settings are remembered by the heater between sessions, and the system automatically restores default values after a power interruption.

Construction & Installation Requirements

• Wall construction: minimum R-12 insulation in 16" on-center 2x4 stud walls, with tongue-and-groove softwood interior paneling and a foil vapor barrier
• Recommended minimum flooring thickness of 5/8"
• Heater guard rail (rock/heater screen) required with minimum clearances as specified in Finnleo's installation diagrams
• No electrical receptacles or showers permitted inside the sauna room
• Sauna door must open outward and use only magnetic, friction, spring, or gravity-loaded closures — no permanent locking or latch systems
• Required ventilation: fresh-air inlet vent located directly below the heater, with an air outlet positioned lower than the upper benches and roughly two feet higher than the inlet, sized per UL 875 guidelines
• CAUTION and WARNING placards (included) must be mounted per Finnleo's placement instructions — CAUTION plate on the interior wall above the heater, WARNING plate on or beside the exterior door at eye level
• Contactor must be rated for a minimum of 250,000 operating cycles

What's Included

• Himalaya 9.0 kW heater unit (240V, single-phase, 37.5 amps)
• 210 lb of vulcanite sauna rocks
• BWT (BioWater Technique) integral water tank with fragrance diffuser
• Heater mounting bracket and rock guard/heater screen
• CAUTION and WARNING safety placards
• Installation and operating instruction manual
• Optional bundling with SaunaLogic2 control (Wi-Fi or non-Wi-Fi) and matching contactor (CB) box
• Optional lighting package (3–8 fixtures) and Bluetooth audio package, sold separately and controlled through SL2

Why Buy Finnleo from Us

Finnleo, built by Sauna360 in Cokato, Minnesota, is one of the most trusted names in authentic Finnish sauna. Every heater is safety-tested and listed for North America, and the SaunaLogic2® ecosystem ties your heater, lighting, and audio into one app-controlled experience. As an authorized Finnleo dealer, we offer full factory warranty coverage, expert sizing help, and support before and after your purchase. Have a question about fit, voltage, or lead time? Reach out and a sauna specialist will help you spec your Himalaya 9.0 kW correctly the first time.